Looking for reliable and not expensive way to cut let’s say from 2m cylinder (d=6-7cm) exactly 20cm long pieces.
It should be cylinders between two plates, so I need exactly 90°
I guess it is part of the design but I am rather interested in knowledge why is it happening.
It is cylindrical outdoor lantern with white/rgb running lights. The point is if I can rebuild it to lightning even when charging
Yesterday made form from paper, today morning modelled in Catia and afternoon small corrections and it fits. Fixing it with fan is simple task in comparison.
Used some special filament we use in our fusion device so I hope it holds some rough rides. Thanks again for ideas I got here
Got ESC cooling fan with 2 pole black connector and y cable (3-pole black male/female-only two wires connected). No position to wire to. Only idea is to put y cable to servo output but I guess fan would be powered only when you turn to side.
Another idea is to buy that t-connector to put it between battery and ESC.
Second question to another fan. It is with molex and connections on ESC is even smaller molex sort of connector. Dedicated for lights actually. Is there workaround without soldering things?
How Neurofunk DJs tag tracks to differentiate between different sorts of Neurofunk? I need some ideas.
State of mind isn’t t same sort like Teddy Killerz. Aggressor Bunx is not same like Ed Rush
Ordered new shocks and received them not completely finished. First question where belongs that bigger round part and second question how should I install it at all? Fingers won’t work
Had accident yesterday and lost tire nut. Assembly manual claims tire is fixed with screws. It is not. I tried my generic M3 nut with lockwasher and it seems to be ok and also enough treat. Can i use it or are the forces there so enormous that its not going to work?
I saw macgiver style with motherboard distance screws but I can’t reach power button. Any ideas how to mount it and get enough cooling power?
I was in process of dismantling one swollen battery pack as I unintentionally tipped that outside plastic layer with soldering iron and it released gases from inside. Battery didn’t explode, only smell left the device. Is it toxic?
Looking for possibility to set every first bar in either different color or at least bigger. I know in the upper taskbar are both tracks visible, id like to have it rather in the wave directly
When taking off (1st gear) I put foot on gas pedal and it linearly increases RPM up to about 1500 RPM. Then, either RPM stalls or drops down a bit (gas pedal position remains same) and RPM goes again linearly up, eventually jumps (correctly) in 2nd gear.
Since it is my first pseudoautomatic gear box, I want to ask experienced enthusiasts if is it normal. I don’t think so. Even my old manual didn’t do this.
Skoda 1,5 dq200 2021, 90tkm
Received my first basher to get in touch with community and my front wheels are probably misaligned. Either one is straight and second slightly turned (left front) outside or both “conical”. While driving, car goes straight without pulling to either side.
Also second question: if I rotate with front right wheel forward, left front wheel rotates backwards. When driving on roads, both sides are going same direction.
And last question: when I rotate front or rear wheels slowly, I get clacking noise. When rotated faster, noise disappears. Not sure if it is correct or not.
Having this substance wondering how to check, if it is at least Tryptamine. Could I take results from 4-ho-met or due to this propio group males things complicated? Should convert into 4-ho-met in the body, at least partially
Full name: 4-propionyloxy-N-methyl-N-ethyltryptamine
Mounted front wheels are bit bigger than expected. How you guys solved it besides another set of wheels
I was treated 8 years ago and now I identified new bulb. I have huge anxiety that it has to be removed again and I loose sensitivity in another part of the leg.
It’s rather seeking-for-support post than help. 😢