I have an SV08 that’s stock except for the MicroSwiss hot end. I’ve been printing fine with the 0.4mm nozzle and both PLA and American Filaments Transparent PCTG. I switched to the 0.6mm nozzle and Fusion Filaments PCTG. Now I can’t even print a temp tower. I don’t know what to check.
The temps are the OrcaSlicer defaults for PCTG (280-240 in 5 C° steps). 0.3mm Layer Height. Everything else are the defaults for PCTG.
I’m having Frontier Fiber installed with a dual eero mesh setup. I’ll eventually want to do a wired back-haul, but I won’t need that initially.
The plan, at this point, is to have the ONT nearest the fiber drop, put the primary eero Max7 and in my home office, run one the “other” 10GbE port to a switch in the office and then use MOCA 2.5GbE to back-haul the other eero Max7.
But, that’s just based on looking at the ports on the eero Max7, and making a lot of assumptions. But what really is required for a new install?
* What cables come into the house?
* What port(s) coming out of the ONT are used?
Given driveways, sidewalks, etc. the fiber will have to come into the opposite side of the house where I want the “primary” eero to be.
* How close does the ONT need to be near where I want the “primary” eero to be?
* Does the ONT connect to the 10GbE port on the eero Max7?
* Do I have to use the other 10GbE port to connect to the other eero Max7?
* If so, can a 10GbE capable switch be between them?
* Can I run the ONT into a 10GbE switch and then the two eero Max7s and the few other 10GbE devices off the switch?
* Would I loose much real-world throughput using 2.5GbE (over MOCA, if that matters) as wired back-haul?
It’s been a while since I’ve purchased a physical PreCon. I just purchased two decks because I had an unexpected chance to play. The last two I bought (Final Fantasy) came with codes that allowed you to play the deck in Arena. Was that a short term special?