u/Rough_Community_1439

Its a Cincinnati millacron arrow 750. I combined two dead drives to get a working one. I found out that one of the boards were bad. It apparently was the one that held the parameter for orientation. Is there any way to get the tool change orientation without using kollmorgans motion link software? Last time I hooked a computer to the drive it caused about $7k in damages as I fried a workstation board, the drive and my PC and a bridge board.

Went and dragged the wrong texture into unity.

I put the wire on the wrong terminal so it shows when I have oil pressure rather than when I don't.

You wake up to a novabeast trying to get your attention. They say that your actions on vrchat has angered a wizard in the lobby. But due to the novabeast calming the wizard down they managed to prevent you from being banned but you must choose one of the two punishments for trolling in VRC.

Option 1: the wizard teleports you to the last world you were in. It behaves like a permanent public lobby that's pinned to the top of the world list. You have to last 3 years in the lobby and then you will have the option to be released back into society or to stay in the game.

Option 2: you become the last avatar you were playing as. You won't be transported to a Vrc world but rather you must live your daily life as the previous avatar you were playing as. After 5 years you will have the option to either become yourself again or to choose to stay as the avatar you were.

Engine is a mitsubishi G63B the tensioner and idler pulley were replaced at time of changing. The belt was made by Continental

Avatar is ziva by sturmwolf.

So I wanna add more fluff to my avi but the problem is that when I followed the same steps for the prefab that did the skeleton, it didn't work. How would I make the extra fluff see through via adjustment of a radial toggle?

This is my daily group pings... If it hits 99 I can't load in.

So I have a cat 242b skidloader that ran away. I shut the key off when it took off. By some miracle it died out before it ran out of oil without throwing a rod either. The unit went way past redline with the injector pump shut off from fresh fuel(key off). I already replaced the turbo but it's not behaving like it should. If you push the throttle up past half way there is a noticable black smoke cloud and when you are around 2k rpm the throttle is all over the place. It jumps between 1200 to 2,600rpm with motion of the unit. You hit a bump and it either stalls down or revs up.

So they been with the ram since February, the ram(black sheep) seemed active in April and all 50 look pretty similar in size and shape. Also do you think I should buy an ultrasound machine to check?

So I got some mild concerns about my sheep with her having a potential problem. she has her sides sunken in between the hips and ribs, kinda like a Holstein cow. She is pretty friendly and allows me to do a quick visual inspection by poking her disguised as petting. There's no feeling of ribs or spine. She is up to date on worming and vaccinations I also think she is pregnant as she been with the ram since April. Is this just a normal dorper sheep thing? Is it a sign of pregnancy?

So I was messing around with the explore groups section and I found this group that was going and doing a weekly community night and it had so many talented people performing music, comedy and dancing. It had the vibes of a chill music festival on the beach. It was so fun to just relax and vibe with people while watching a cat play an original song on guitar. I will definitely be back.

Group code: OPENMN.7338