u/Unable_Degree_3400

After installing a special version of software, I got this. I disconnected the WiFi and shut down the router immediately. Tried to close it but would keep popping up then shut downs the computer and turned off all access to internet. After turning on the computer it did not show up, the software is downloaded and working. It seemed like it was scanning every single file in my computer. What is this, is this very serious? How can I get rid of it?

The first picture happens when I completely shut it down not often but intermittently. Stays on it for 2 mins until it loads or it doesn’t load and I get an error.

The others ones show up sometimes when ever I try to go into the store.

FIFA 18 won’t update, it played when offline but it would crash sometimes. Could this be related to hhd failure? I recently added thermal paste Mx-6 to the APU.

I get only blinking green and sometimes blinking green then red. I re did the soldering on the points to get clean solder, this was the 2nd redo for the points with 4.7 k ohm resistor’s

So I am getting no display and flashing green and tunes off and I am getting flashing green then red. I read the end I created the.Cell and I wrote the xell no issue, but then I got this. I am using a 4.7 k ohm resistor and I have done 2 rgh3 the same way no issue, what is the cause? Did I completely destroy the console?

what are the Hdmi component names values of the black components and the green one?

How do I inject voltage to the switch lite to activate 2nd boot? I have the guide. It it shows only the switch , and the power button is different as well for turning it on

Would the tvs diode (5.6V) be the correct one for the ps5 HDMI in the back?

As for the capacitor 100nf is it the 25V or the 16V? This is for the one next to the hdmi port. Does anyone here know about this?

Does anyone have the schematic diagram that shows the exact values for the components of the HDMI front and back?

Where could I get the foam pad for the PS5 APU? I accidentally spilled some liquid metal where I highlighted. I tried to clean that up, but it seems like there’s still some there. Would it be OK to leave it there or I have to replace the whole pad?

What are the most used in common? BGA recalling ball sizes used for the electronic repair.

So that describe is not spin after you answer the game anyone here I have experienced fixing this problem for this Xbox 360? Here is a video of what’s going on, anyone have tips on how to start diagnosing?

I recently installed gullikit tmr analog sticks it seems they are no good is this because they have not been calibrated yet or is this how it shows if it’s defective before the calibration can anyone here share their experience with these analytics from this company? The analog stick on the left side is the.TMR AND THE ANALOG STICK ON THE RIGHT SIDE IS THE ORIGINAL ANALOG STICK THAT CAME WITH. This is the second TMR that I installed on the left joystick. The previous one was even worse than this.