u/Albert_Simon

Two years ago I had an issue where my 2017 Highlander XLE wouldn’t start. After checking the codes and looking at other possible issues, I had to replace my mass airflow sensor. I recently had the same problem occur and had to replace it again. I used OEM replacement parts each time. Is this a known issue? Any idea why this would keep happening?

Years ago, Chili’s offered these boneless wings with an Asian style sauce. The dipping sauce was a wasabi ranch, but I can’t tell what the wing sauce was.

I’m looking at aftermarket android screens for my wife’s 2025 SR5. Both Lexland and CarTrimHome offer 14.6” screens. Are they the same hardware? Any idea if one is better than the other?

My wife and I just became the proud owners of a 2025 4Runner SR5. I have seen some aftermarket wireless charging pads that fit in the phone storage area. Is there a specific model that’s understood to be the best or highest quality?

I have been trying to take out the safety selector from my Franklin binary trigger pack, so I can swap it to a different lower. Based on the instructions and videos I’ve seen, I’m supposed to remove the hex screw from the right hand side. I checked what size Allen key I needed to use, but even when I used that, I stripped the screw and it is refusing to come out. Am I doing something wrong?

Looking for recommendations for a hair stylist familiar with men’s medium to long hair. I thought I had found one but they want $60 for a haircut! Any help would be appreciated.

I was thinking about swapping my current suppressor host (PPQ) for a Platypus. Anyone have experience using the Osprey 9? If so?’c how does it run? And more importantly, how does it look?

I couldn’t find the answer to this when searching the sub. I am looking at getting a CAT MOB for my AP5 and 300 BLK Dissent. I want to use a Night Howler with a low profile mount, but from what I’m reading I need to make sure the blast chamber has 1.5 -1.7 inches of clearance. Does anyone know the specs of the CAT MOB blast chamber using a mount like this?

Anybody use this or similar set up? I’m looking to get a “flush” fit.

Friend of mine wants a PCC that will be reasonable to install an FRT on. I immediately thought of the Dissent or a custom-built AR9 with the MAT9 upper since they have delayed blowback systems, but I have no experience with FRTs. Is there a platform that’s considered optimal among AR9s?