u/Dudegay93

The circuit works at around 22.4mhz

Also does anyone know why i couldn't make oil fly and what cool things can i do with this?

I made this induction heater but for some reason when i power it on its not working and my psu has to drop voltage from 12v to 6v for it to be 5 amps and my mosfets also get hot

Specifically one of the fets gets hotter then the other but both of them get hot

I turn on my psu first then connect it to my induction heater

I made this induction heater but for some reason when i power it on its not working and my psu has to drop voltage from 12v to 6v for it to be 5 amps and my mosfets also get hot

Specifically one of the fets gets hotter then the other but both of them get hot

I made this induction heater but for some reason when i power it on its not working and my psu has to drop voltage from 12v to 6v for it to be 5 amps and my mosfets also get hot

Specifically one of the fets gets hotter then the other but both of them get hot

Hello, I need to put a bms on a 2s battery pack (2 18650 lithium batteries) but i only got a 3s bms so i was wondering if i could use it as a 2s bms by connecting my - to 0v, middle point to 4.2v and + to 8.4v and not connect anything to 12.6v. I am also wondering if i can charge i5 with 8.4v charger or do i have to use a 12.6v charger?

hello, I need to put a bms on a 2s battery pack (2 18650 lithium batteries) but i only got a 3s bms so i was wondering if i could use it as a 2s bms by connecting my - to 0v, middle point to 4.2v and + to 8.4v and not connect anything to 12.6v. I am also wondering if i can charge i5 with 8.4v charger or do i have to use a 12.6v charger?

Hello, I want to make a powerful induction heater and was wondering if i had missed out on anything in my pcb

Also do i have to make my tracks width (last image) 100mil instead of 150mil bc jocpcb says that it is fine

Hello, I want to make a powerful induction heater and was wondering if i had missed out on anything in my pcb

Also do i have to make my tracks width (last image) 100mil instead of 150mil bc jocpcb says that it is fine

Hello, I want to make a powerful induction heater and was wondering if i had missed out on anything in my pcb

Also do i have to make my tracks width (last image) 100mil instead of 150mil bc jocpcb says that it is fine

In the video its around half power(7v) as i dont want to try full power without resin. Before i have made this https://www.reddit.com/r/ElectroBOOM/s/m2NxbCBMr9 magic board (not wand) so i decided to make an actual wand this time so here is the progress so far, also my cw muktiplier is much smaller and neater compare to last time
https://www.reddit.com/r/ElectroBOOM/s/dllyUG9l6f

Sry for bad quality video

Also would i be able to get even better results with 10 stages or would the losses take over?

The phone does not obey others any more

I had made this tesla coil half bridge driver and i wanna know if it would work or not

Vid of it https://youtube.com/shorts/HKJ\_2T6TdZ8?si=O-ilKDhnFEJQepoR

I am NEVER doing deadbug style smd component soldering ever again