u/Willie_Howell

I was trying to upgrade the software on my Ender 3d se before I installed my Nebula pad but I may have chose the wrong software. I have a 14 motherboard and I think I tried to install the software for a 13 mb. So things were not working, couldn't get the unit to boot. So with having the nebula kit I thought I would go ahead and install that. Nope won't get past the network set up point. So my delima is what to try next. Do I try to unbrick it by going back to the original software, proper one, and then just, when I get it working again, and just install the Nebula kit to get it to work again. Will reverting to an older version of the software un-brick my Ender 3 se?

I've had this going on for a couple of weeks now. When I first start up stn I get this and then it goes blank screen and then it goes back to swirling bubble and then it goes blank again. This happens when I first start it and lasts for about 20 seconds then the video will play fine for however long I watch it. Nvida shield 2019.