u/stewardwant

Very new to Ecobee.
I have Home and Sleep Comfort Settings configured.
Home runs from 06:30-21:00, heat at 65, cool at 70, using sensor in thermostat.
Sleep runs from 21:00-06:30, heat at 67, cool at 71, using Ecobee sensor in master bedroom.
If I have the system set to cool, will it only run on cool based on the cool temp settings in the Comfort Setting currently active? Basically just disregarding the heat setting. And vice versa?
Or will it change the system to heat if it gets below the heat temp in the Comfort Setting?

My mom has a 2008 Crown Vic. She was at my place today and said her wipers stopped working on the way over, so I checked the fuses and voltage at the fuses, and everything looked good. Checked the plug on the wiper motor, giggled all the wiring around, etc. Then I tapped on the wiper motor twice with the butt of a hammer, and they started working. Turned the car off and back on, still working.

So I told her she likely needs a new wiper motor, to which she said she’s already done that. She’s put 1 used wiper motor and 2 brand new wiper motors in it in the last 6 months. A few weeks ago she also replaced the wiper/turn signal stalk/switch.

The fact that it started working when I tapped on the motor leads me to believe that’s the issue, but it seems strange that it would be bad already, and that 4 would all go back in a 6-month period.

Any ideas? Is there something maybe causing these motors to fail?

I want to turn my 19.5 into a fairly dedicated suppressed gun. Like 90% suppressed shooting. What should/needs to be done to make it run as efficient and effective as possible with a can?