u/Sup3r10s

What episode was this? Thanks.

Sovol SV08 Max. Elegoo Rapid PETG. Printing basically a disc at a slight angle (almost vertical, maybe 70-80 degree angle). Nozzle at 240. Bed at 80 on the first layer, dropping to 75 after.

The supports go slightly up the sides and slightly on the back. At the same layer height the supports end, the layer adhesion is terrible. Two prints, both of them broke when I tried to remove the supports. It’s very strong further up. It just snaps when I try to remove the supports. Help appreciated. Thanks.

Also, to help ensure bed adhesion, I run it using slow layers. 20 slow layers, starting at 10% speed, slowly working up to 100% over the course of the first 20 layers. I run this setting on my K1 Max and have never had this problem.