Currently trying to figure out which model PI would be ideal to buy for a passively cooled system, as I'm not to keen on 40mm fans. Any recommendations on a silent but safe build, please?
Trying to learn Turkish basics, but hit a wall when realizing that when written, lots of sentences are a single word. I'm having a hard time understanding the concept. Normally, I would learn which word meant what, where it had to go and how it would change. Here, I have no idea which part of the word means what, if it does at all. This makes it close to impossible for me to remember or apply. How do I get around this barrier of understanding?
Act I. First time playing the monk as a casual player on Torment I. Having to kite single or small groups of (trash)mobs to survive fights. Any advice on how to get best started?
There's a jazzy piano loop playing when the main character enters his home / HQ.
This YT video plays said in-game loop. Any ideas on the song / recording?
Having read the FAQ and consulted the supported codec list of version 19, I still can't get imported media to work properly. While the inapp preview will play audio and video of a file just fine, setting the clip on a timeline removes the audio. There's no mute or filter active. The file also shows no data / wave in the audio stream. Pretty much out of ideas how to oonvert media using Handbrake so that it will work within Davinci.
Made the switch to Nobara and and installed Clam UI. It shows the ClamAV daemon is not running and offers a commandline to start the daemon. However the terminal the daemon can't be found when executed in terminal, despite it being installed in the dnf.
ClamAV installation OK
Freshclam service ACTIVE
How do I proceed to find the issue, please?
When in mouse settings, my Keyboard model (Corsairs Strafe RGB) is the standard shown as one of the three available mice. The other two options are the actual mouse (Hyper Pulsefire) and a "consumer control" version of said mouse.
In keyboard settings however, it does not even offer my Keyboard model in the dropdown menu. Instead it's recognized as a generic keyboard.
How do I get the correct setting for each device?
Also, excited to see I can remap mouse buttons in the mouse settings - but is there a way to create profiles to switch between?
Refreshing every few minutes, I get only 3-5 threads per section. This is a common occurrence, what's going on?