How can it possibly be this bad? Is it intentional? You can never find what you're looking for, search function is a fucking joke, suggestions have absolutely nothing to do with anything I've watched in the past. Pausing any event and trying to restart it has a 80% fail rate. It's absolutely ridiculous.
I'm trying to find a new carb for my Honda Generator. Apparently it has been discontinued and it's about $250 for a replacement. Has anyone had any luck with a cheaper retrofit?
I've tried cleaning it, but it still won't run without the choke closed, and even then it surges the entire time it's running, plus there's a small gas leak on top of where the bowl screws on to the top that I can't seem to find.
I was expecting the story to be told through audio recordings from Manson. Instead. It was just bad dramatizations, and third party narrations of Vincent Bugliousi's version of events.
The only redeeming quality was new interviews with a few of "his girls", but that contributed nothing to what the highlight of the"Tapes" documentaries should be.
Washer is a little two years old and in January I replaced the water inlet valve because the second valve from the left (the cold water fill valve) was leaking. The new valve workedat first, but this week it began leaking again from the same location.
I replaced the valve a second time. After installation, it operated normally for about five minutes, then stopped filling. At that point, a high-pitched electrical hum started coming from the cold water fill solenoid, and the solenoid became very warm to the touch. Eventually, the washer displayed an IE (Incomplete Fill) error.
I powered the machine off and tried again. The same thing happened: the valve would begin filling normally, then after a few minutes it would stop, the humming would begin, and no more water would enter.
To troubleshoot, I moved the electrical connector on the harness for that valve from the cold fill valve to the hot fill valve. The exact same behavior occurred, except now it was the hot water fill valve that hummed, overheated, and stopped filling. Because the problem follows the electrical connector rather than the valve itself, I don't believe the inlet valve is the issue.
My questions are:
What could be causing this behavior?
Where does the wiring for that valve terminate (main control board or another component)?
Could an electrical issue have been causing the original valves to leak or fail prematurely?
What component(s) should I replace or test next to permanently resolve this problem?
I'm on my first rewatch since the show premiered, and I've grown older and my wife and I have had a couple of kids and am noticing something I missed the first time. Mary is an absolute smoke show. George is one lucky man.
Thanks for coming to my Ted Talk.
Has anyone found an equivalent to these which were discontinued? The last thread on this sub was about a year ago, and all the links are dead. Any help would be appreciated.
8f176b239814f0b9
Will delete when redeemed. Thank you!!
Fresh Promo Coupon Code. I will delete when redeemed.
THANKS!
c0f1940cc5f6d069
Is there any reason not to purchase off Amazon. It's significantly cheaper? What's the catch?
Does anyone know where I can get personalized leather belts? There used to be kiosks in malls and flea markets but I haven't seen one in a long time. Thanks for any tips.