



OG DMG: lcd with BoxyPixel buttons
GBASP DMG: with boxy buttons
GBASP DMG: with boxy buttons
OG DMG: Boxy cnc shell with boxy buttons
Direct from the Ukraine! The paper sleeve is printed on an old Soviet map lol
Hey again everyone! My Lisa + Profile officially is "restored". The system was recapped and has a new replacement backplane. Original was saved. Last issue was a 5v trim pot in the psu lol
I seem to have a CPU, I/O and two ram cards. What are some "must haves" for this machine? Obviously an ESProfile, but any cards I should look into making from here? https://github.com/alexthecat123/Lisa-PCBs
Next is getting it talking to one of my wifi modems so I could get online!
Hey again everyone! My Lisa + Profile officially is "restored". The system was recapped and has a new replacement backplane. Original was saved. Last issue was a 5v trim pot in the psu lol
I seem to have a CPU, I/O and two ram cards. What are some "must haves" for this machine? Obviously an ESProfile, but any cards I should look into making from here? https://github.com/alexthecat123/Lisa-PCBs
Next is getting it talking to one of my wifi modems so I could get online!
Also, has anyone been crazy enough to start rip their vinyl? I finally got a pretty decent vinyl setup/ pre(tubes) etc. Most of my .flacs are 44 to 192khz. Would I see an improvement on some of those lower end rips? I have a usb connection from my TT to my Mac already for a similar experiment a few years ago.
Thanks!