u/Square_Atmosphere_12

EMR pens are not compatible with Precision Pens, why put restrictions on pens. When I've tried a EMR pen on a Levono screen and the feel was exactly what I want.

I was unaware that my Levono tablet could not accept a EMR pen; does anyone know if it's possible to get it to work ?

Ddrescue finished a day earlier then mentioned. The results are available.

Only 140 Gigs was Rescued from a 255 Gig Drive. There were 63488 Bad Sectors, 124 Bad areas and 1_749_382 read errors. The drive was not completely full, although close. It stopped even though it said there was 1 day and 12 hours remaining time.

Is there anything I can try for the remaining 110 gigs; rather then DDRescue and is there any commands I should run after it's finished; before rebooting to Windows.

Ddrescue sorta deceives you when it's in progress to the actual finished result.

How can I backup a tab session from mobile ?

Is there a direct link between Gluttony and Lust / Adultery ? I'm sure I read it some where, for example; you eat too much, not peanuts or berries but more refined foods that may lead to any form of Adultery ?

Can these two demons work together on a person if it's habitual for the person ?

What is better for data recovery UFS Recovery Pro or DD Rescue ? I had to ask such a question but upon searching, no one else has ?

Duck Duck Go really is not that great at blocking porn; with a little test, by switching safe search to off the thumbnails where quite revealing what was happening. This is too easy to just see; I was expecting it to be a little more obstructing but it wasn't.

What is the best software to restore data from a failing hard drive / M.2.

I've tried Aomei partition software but since the drive has some bad clusters when the cloning finished; the software informed me that the drive could not be cloned. It goes though with the cloning but at the end; actually fails to clone.

The data exists, along with Windows but I need to clone it to another partition then, clone that to a Windows Boot drive.

When booting into my computer the M.2 drive is detected; although within the BIOS or Windows Disk Management this exact drive is not visible ?

Disk Management should show an MBR drive, although it's not.

How do you clone an MBR drive which doesn't boot to a GPT drive without data loss ?

Is it possible to clone just the data partition only; so that the drive boots as GPT but all the data is recovered ?

When the computer boots, I can see all my drives; although, in the BIOS > Boot > Boot override only one drive appears which is faulty, my Windows drive doesn't appear ?

The BIOS which I'm using as the option of legacy boot as I must install Windows10 on a MBR system, but my BIOS is not making this possible ?

When the computer boots, I can see all my drives; although, in the BIOS > Boot > Boot override only one drive appears which is faulty, my Windows drive doesn't appear ?

Windows is currently not booting into Windows, even through the BIOS. Although what I've realized is that when using a USB boot drive to boot into a Windows recovery mode then starting diskpart. Then listing the volumes, it will show Windows; although sometimes restarting the computer and running diskpart once again it will show that same Windows volume as RAW.

Within diskpart the Primary Partition is active. Although the volume status is healthy. I've tried bootrec and all of it's commands although that doesn't work and it won't Rebuild the BCD using the command bootrec /rebuildbcd; as it can't find any Windows installation, although one exists.

When I try to boot directly from the BIOS into Windows on the drive most of the time I get a 0x000000f error informing me the BCD boot is corrupt.

I want to fix using typical command tools but chkdsk E: /f which is the drive for Windows won't run because the volume is write protected ?

I got an issue that is over a week that should have been resolved but it's not.

A few weeks ago, I did a BIOS update; that BIOS update claimed it was successful upon rebooting it wasn't. Therefore I changed by motherboard and CPU, they are installed and so is the new BIOS. Except Windows won't boot, even from the BIOS. I've tried `bootrec` commands, nothing works.

There is a version of Windows10 on the drive and it's healthy but it's file system is MBR. And all the data on the drive I cannot loose. Trying to use diskpart to get the drive active doesn't work it returns an error; although sometimes the volume with the healthy Windows file system can go from NTFS to RAW, and so It no longer is a Windows volume as it's a RAW file system. Then sometimes after restarting it returns back as a Windows volume.

How can I fix this, I can clone the drive but this will just duplicate the issue although if it's a hardware issue this may be eliminated with a new drive; it just won't boot into Windows. After over a week, I just want to get the system back up since installing the new hardware.

I'm in need of how to get Windows to Boot after a hardware change as the bootloader is damaged although the data on the drive is extremely important. And I've tried a lot of solutions online which have not worked.

I'm in need of how to get Windows to Boot after a hardware change as the bootloader is damaged although the data on the drive is extremely important. And I've tried a lot of solutions online which have not worked.

When cloning a drive which is a Windows Boot drive. Rather to clone the drive, but if the drive doesn't boot from the source. Delete the other boot partitions and re-create them without loosing the Windows drive using diskpart ?

Therefore making Windows Boot, except on the new drive.

When cloning a drive; especially if it's a Windows drive with all the boot partitions etc. How can I clone as so that, it doesn't carry over the boot problems on the previous drive to the new drive; rather just windows and all the partitions required for windows as so that the BIOS will find windows and simply boot into it ?

Also would it be advised for a new drive to make it UEFI, then copy a MBR / GPT Windows partition and expect it to work ?

How come I can't use a track pad on Edge Mobile to scroll a page ?